Change the "Close" menu option to "Save and Quit".

This would be much more clear in what is happening.

Add a key in the calibration area where you can save and import a list of angles because every time you create a probe you have to start from zero.

As a TubeShaper user, when I import a CAD model that contains assembled tubes with or without brackets (IGES/STEP), I want to be able to select wich one has to be extracted and afterwards measured/reported.

It will be nice to have a Preview window of the CAD model and select which one has to be extracted, and also to select which straight, of the selected tube, has to be considered my 1st one.

Regards,

Liviu

CMMs need the option to have wireless jog boxes. I trip over the cord all the time and wheel over it with my chair.

Looking for a way to populate results in specific custom order in Excell based first article travelers.

Crazy as it sounds, but we do have straight tubes that we measure too, some with flanges or fittings at the ends.  I know that there is the toolbox to measure a straight, but it is limited to just a straight.  Would like to be able to create and inspect a straight tube with or without flange profiles and check for the deviations.

UK customer has requested a way in Inspect to specify a % of tolerance, and if dimensions are within tolerance, but above the % of tolerance, they would be marked in yellow on the dimension summary screen at the end of execution.

We need more Variables ind the Header of the Protokoll.

The Customers need to insert.

1. Customer

2. Part

3. Controller

4. Tube Material

5. Bender

6. Comments

7. ...etc.

Would like to be able to view the CAD model within the Inspect user interface while the program is executing. Similar to the current Operator mode functionality.

Now PC-DMIS remembers only measurements made on the last part. A lot of time I need a complete data of part that was measured in past. It could be set to remember last xx measured parts. I know that Calypso has this feature.