Add a 'mark used' parameter set option to the Autocalibrate/Probe command.

Basically I'd like the LoadProbe, Mark used, Measure sequence to be automated.   

I've never created a calibration parameter set that wasn't created from the marked use checkbox on the load probe command.  It's hard to imagine a case where I wouldn't do this unless I wanted to recalibrate an individual probe under program control.

Doing this could eliminate the possibility of forgetting to update the Parameter set when the measurement routine is updated. 

PC-DMIS Customize process needs a total rebuild. Example: The User Defined Commands that will create numerous copies of the same customize commands. This has been an ongoing problem for years now. And a much needed improved workflow is a must.

Here is an example. Look at the caption below and you can see that there is two Move Feature commands.

I have lots more examples if needed.

I'd like to be able to report multiple runs of a part within pcdmis. 

when doing a profile with form and location add a check box for the basic location.

I want to be able to select multiple CAD surfaces and have PC-DMIS 

automagically create vector points on those surfaces based on a predefined set 

of parameters.  For example, I want three points, equally spaced within .05" 

diameter tolerance zone, at random locations, at no less than .100" from the 

edge of the surface(s).