Add "marked used" parameter set option to AutoCalibrate/Probe command

Kingsld1 6 years ago in Metrology Software / PC-DMIS updated by neil kay 4 years ago 0

Add a 'mark used' parameter set option to the Autocalibrate/Probe command.

Basically I'd like the LoadProbe, Mark used, Measure sequence to be automated.   

I've never created a calibration parameter set that wasn't created from the marked use checkbox on the load probe command.  It's hard to imagine a case where I wouldn't do this unless I wanted to recalibrate an individual probe under program control.

Doing this could eliminate the possibility of forgetting to update the Parameter set when the measurement routine is updated.