By showing both it gives a good indication of how angled the cylinder may be.

Allow to change the number of exported decimal places independent of the report (see attached picture).

Or.. if this is too much to change -> force the excel export to always export at 6/7 (mm/inch) decimals.

This would allow to have an easy to read PDF/Print but still retain all the Data in the Excel Export.

At the moment if the PDF/Print is set to 3 decimals the export is also just 3 decimals.

This leads to PDF/Prints that are out of tolerance (shown red) but exports that are shown as in tolerance (wrongly)

i am currently working in inspect 5.1
Currently, the slideshow does not display well angle, distances etc. that refer to more than one element.

Is it planned to imply the possibility of additional dimension lines? 

Many customers have large enough machines and smaller parts facilitating the ability to load multiple fixtures on the machine.  It would be helpful to have the ability to specify spacing between fixtures to execute sequentially.

This could possibly be done with fixture alignments rather than spacing for provision where the spacing may not be uniform.

Hello,

we need to have the option to show the vectors of the deviation in our protocol.

It is possible in the graphical window in PC-DMIS, so why isnt it possible in the "CADONLY" protocol e.g.?

Here is a screenshot what I mean:

Thanks in advance

Using 2021.1, an "analysisview" command of a feature control frame that uses the "U Modifier" will ONLY allow us to put on the inspection report an "analysisview" of a BILATERAL tolerance band. 

Please add the capability for us to show the tolerance band as UNEQUAL. 

add a color scheme to the summary view, similar to the edit window color scheme that can be saved and recalled.

Add a feature in the screen for editing a feature (plane, cylinder, etc) to assign it as a datum instead of going through dimension datum screen and/or gd&t dimension.