It would be nice if you could tag programs in Windows explorer and be able to add comments about the program without having to open the program and view it. This would be display in windows explorer under the details section.

If there is a large number of programs to load within a Directory, Inspect slows down significantly and sometimes crashes. If the only program to show was, searched for, program. This should prevent the system from slowing down.

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

Ability to lock out or block certain programs or programs within subfolders to keep other cmm operators from using these cmm programs.

It would be nice if we can handle STL by surface mesh. Pointcloud is not usable...

Some youtube demo about pointcloud operation is also much better to help to our work.

Practical trick and tip etc...

Improve quick fixture interface to where it is more like the translate mode, 2d rotate mode, 3d rotate mode in the graphics modes toolbar.  Current interface is quirky at best to downright difficult.  

 I would envision going into quick fixture mode, click on a component, clicking on translate to move a component such as a tension clamp, then switching to 2d rotate to turn the clamp on to the cad model. 

Add ''Nominal, Measured & Deviation'' shortform label to Data view (LRA, XYZ & ALRA) & Report.

Have the Excel output work with any number of pieces into the same sheet.

When you have a form you can't see it in  the pop up window in inspect,you need to hit next to go to the next step of the program.All the pop ups should be visible to know what to do.

Currently the PLP alignment priority is plane-line-point.
if can be customized priority, points can be origin.