Our company recently up graded to 2017 r1 from v3.7. a big jump I know.

our CMM inspectors had been very efficient at creating reports of OOT. for manufacturing and or engineering. We used full report mode that was a live function that we edited the program and graphics from. Snap a screen shot and import it to a excel doc. Like the example above.

Now the report is a text doc. and not live to the graphics at all. We are constantly switching back and forth between report and summary mode. If I could create a graphic like that one shown and get it into the current report would work also.

Can we get the full report mode from v3.7 added back to PCDMIS?

It was a great tool for us, and easy to use.

A lot of my parts have geometry that is weird enough to warrant me to measure points and then construct a feature out of those points as opposed to using an auto feature. This works well but it kills me because it takes up a lot of program window space. I would obviously much rather use 1 auto feature as opposed to having 12 individual points and then a line about the construction of those points.

It would be cool if I could put points on my model, go into construction (or perhaps a new dialogue box) and click to create an auto feature out of those points. I am imagining the software grabbing the nominal XYZ IJK values from the points previously mentioned and using that data to create as well as place an auto feature in my program window. Id then like to be able to go back in and delete those points, thus greatly reducing the size of my program but having the hits for my newly created auto feature precisely where I want them.

viewing path line is good, but will be better the make a different color between measuring path, rapid move, security move,...

Hello,

Actually the progress bar don't show the really progressive routine. it's be simple that PcDmis calculate the total number of features (Element) and the % of progressive bar will be calculate on that.

the same pb on Probe calibbration. the % can be calculated on the number of the contact to measered. and the windows can show the actual contact angle that being calibrated.

We have some machines that use PH10 and some that use Tesa probe heads, it takes some time to convert probe angles when a measuring routine was created with one of these probe heads and needs to be run in a CMM with a different probe head. It would be great that a PC-DMS recognizes this scenario, settings editor gives you limited options in the AutoAdjustTesaM5Degrees and in some cases it doen't work as intended.

Add the ability to right click on a path line segment and jump to that section of the program after the last feature or move. Or before the next feature or move.

When doing a fixture certification, it would be nice to be able to EXTEND a CAD surface along the current plane (maintaining the surface vector) to check a FLUSH detail if your using a part model instead of the fixture model.

When measuring a half circle in the middle of a tube for example... the change in function would eliminate the need to add move points and create a alignment to the first feature created.

Path lines from curse does not stay active and needs clicked to reactiveate.

Show path lines for highlighted code only option.