Similar function to min_circ and max_inscr of a circle.

Potentially using Std.Dev. and allowing to use points only in +% or -% of Std.Dev.

Ex.  I'm using backlight only on gasket material.  It would be useful if
I could Snap the line to the points that are either a minimum or
maximum (depending on material side) To avoid calculations with debris.  In this example lets assume a minimum edge is what I'm looking for.  I select to eliminate 75% of points on the positive side of material (75% of the standard deviation).  I'm then left with 25% of the points to construct a line out of, of which are ignoring 75% of the imperfections seen on the surface.

Make Xact measure report easy to re-arrange so it looks like the Legacy Report.  You can shutoff and turn on whatever you want to go to the printer or stats (in whatever order you want) .  In machining all the machinist cares about is which way they need to move the machine.  All they want to see for Position for example is X, Y, Diameter Size and Position.  They do not want to see datum shift, the position of the datum's you used, the size of the datum used.  The Report is to long and confusing and out of order.

Make possible to set which axis will be displayed in report by default. At this time when I use Xact Measure GD&T almost all axis are selected but I dont want them in report so I need to unselect them all except for those which must be displayed. I need to do that at every single GD&T result but when you change just one alignment all axis will select again and I need to do all the work again and again. It is really annoying. 

In the older versions of PC-DMIS; prior to clearance cube, when using clearance plane you could simply type "move/clearplane" within a non auto feature and if would clear the plane and stay there until it was time to take the next hit. Clearance cube is a superior tool in most regards but I have to add move/points when ever I want to deviate from the path. I would like to have the same kind of thing with the cube; It would be very helpful to have the ability to clear the cube when ever I see fit. Even within auto features and scans. Please ask if you would like me to better clarify.

it helps when the same program run on different machine that i can know which machine they run on my report and able to make some adjustment per machine type.

Would be great to have to option to have a check box that if checked whatever settings you type in under the actual’s tab would also populate the data fields in the nominal s tab. Also to go a step further if the programmer had the ability to click “select” an already created featurs that the generic feature utility would be able to recognize and extract X,Y,Z, and I,J,K’s dia ect… and or drop down list of previously created features.

Add a 'mark used' parameter set option to the Autocalibrate/Probe command.

Basically I'd like the LoadProbe, Mark used, Measure sequence to be automated.   

I've never created a calibration parameter set that wasn't created from the marked use checkbox on the load probe command.  It's hard to imagine a case where I wouldn't do this unless I wanted to recalibrate an individual probe under program control.

Doing this could eliminate the possibility of forgetting to update the Parameter set when the measurement routine is updated. 

PC-DMIS Customize process needs a total rebuild. Example: The User Defined Commands that will create numerous copies of the same customize commands. This has been an ongoing problem for years now. And a much needed improved workflow is a must.

Here is an example. Look at the caption below and you can see that there is two Move Feature commands.

I have lots more examples if needed.

I'd like to be able to report multiple runs of a part within pcdmis.