it would be nice to have the ability to update the screen after an best fit. now i have to remake the coppcolormap to see the new deviations. what i'm whishing for is the posibility to jump around in the program with different alignments and see directly the chanche of deviation live on the screen.

Portable measurement lasertracker:

For faster measuring jobs it would be nice to have the ability to measure holes by just laying the sphere with or without an adapter in the hole and measure directly to the centerline (cad/curve)without defining the hole at first.

Gostaria de saber como inserir pontos ND quando usado a ferramenta FCF

Gostaria de saber como utilizar Datum target no PCDMIS

Gostaria de Saber como avaliar requisito simultaneo no PCDMIS

Gostaria que o Software desse a opção de Ativar o alinhamento de cada elemento avaliando , por exemplo eu tenho um perfil de superficie em relação a Datum A gostaria de poder alinhar minha peça apenas clicando no Datum A como outros softwares ja fazem , avaliação de Pattern de furos aonde conforme descrito na ASME 14.5 o valor que sai e o maior cilindro que se afasta da nominal, na verdade precisamos de mais suporte em relação a ferramenta FCF pois infelizmente não temos retorno sobre nossas duvidas.

In my programs Routines I use different "Marked Sets"

The execution time is not calculated corretly in the "Marked Sets"

The "PC-DMIS" should gives the correct time "Marked Sets"

When displaying transparent Analysis views over a CAD-object in custom reports, it is very time consuming to get the scale and orientation right. As these properties must exist on the CAD-object, it would be very good if the Analysis view could (be told to) pick up those values. I would still need to translate the image to the right place, but that's the easy part.

It would also be nice to have the Scale of the CAD-object as a visible (modifiable) property, to make it easier to get all CAD-object in the right size.

It would be nice to have a statement like this that would not stop the program.

Currently a generic feature has to be created to output this information.

Sometimes the labels get in the way when you are rotating the cad model around. It would be nice if the labels turned off if the measured feature was not visible. Know you can turn them on and off but sometimes it's a pain to turn off all the labels of features that are on the other side of the part.