when editing the tolerances zones (+,-), and the zone is a bilateral equally disposed zone, have a setting where the warning message will then change the pos and neg allowance at one time, rather than having the message pop up for both the pos and neg tolerance.  This can be accomplished currently by keying in the value and tabbing to the next value, however, there are times when using a ten-key pad and mouse, that this is not as user friendly (tenkey pad doesnt typically have a tab key on it).

save per serial number, date time was measured, default location,...

Romer to CMM program import ability to add move clearances, tips, and angles to run Romer program on CMM with conversion and vise versa CMM to Romer as well. This will improve efficiency by not holding up production.

The CAD assembly tool is very helpful when combining/placing multiple CAD models in the graphics window. Currently, I translate and rotate models into position. This is very effective if models need to be accurately placed. But it takes time, especially for numerous models. It would be helpful if the was a "drag" feature to roughly position models. Especially in the case of fixture components which not not require exact placement or roughly positioned before fine tuning placement.

Have not been able to properly view pathlines in online need to always go to offline to view the path. Online versus offline is difficult to understand to operators. What causes the pathlines to not view properly online?

Different user settings and GUI setup would not be changed by other users.

I'd like to be able to rotate my cad model by clicking and rotating a face of the rotation widget.