1. Hexagon Measurement Systems
  2. Metrology Software
  3. Inspect
  4. Ideeën
0
Declined

If "Case" selections are used withing Program, the program Completion ring stays at 100%.

Cian 7 jaar geleden in Metrology Software / Inspect • bijgewerkt door neil kay 5 jaar geleden • 1

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

GOED, IK BEN TEVREDEN
Tevredenheid notities
Satisfaction mark by Cian 7 jaar geleden
Declined
neil kay 7 jaar geleden

Inspect is "dumb" to the contents of the routine, so does not account for such inbuilt logic. However, in the next version of Inspect, it offers capabilities to "measure another part" at the end of execution, which you could swap to use. It also, with the playlist functionality, has the ability to multi execute a program 'n' times.

Customer support service by UserEcho