1. Hexagon Measurement Systems
  2. Metrology Software
  3. Inspect
  4. Idéer
0
Afvist

If "Case" selections are used withing Program, the program Completion ring stays at 100%.

Cian 7 år siden i Metrology Software / Inspect • opdateret af neil kay 5 år siden • 1

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

GOD, JEG ER TILFREDS
Tilfredsangivelse
Tilfredshedsangivelse af Cian 7 år siden
Afvist
neil kay 7 år siden

Inspect is "dumb" to the contents of the routine, so does not account for such inbuilt logic. However, in the next version of Inspect, it offers capabilities to "measure another part" at the end of execution, which you could swap to use. It also, with the playlist functionality, has the ability to multi execute a program 'n' times.

Kundesupport af UserEcho