1. Hexagon Measurement Systems
  2. Metrology Software
  3. Inspect
  4. Idées
0
Écarté

If "Case" selections are used withing Program, the program Completion ring stays at 100%.

Cian il y a 7 ans dans Metrology Software / Inspect • mis à jour par neil kay il y a 5 ans • 1

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

JE SUIS SATISFAIT
Évaluation de satisfaction
Note de satisfaction par Cian il y a 7 ans
Écarté
neil kay il y a 7 ans

Inspect is "dumb" to the contents of the routine, so does not account for such inbuilt logic. However, in the next version of Inspect, it offers capabilities to "measure another part" at the end of execution, which you could swap to use. It also, with the playlist functionality, has the ability to multi execute a program 'n' times.

Service d'assistance aux clients par UserEcho