1. Hexagon Measurement Systems
  2. Metrology Software
  3. Inspect
  4. Ideen
0
Abgelehnt

If "Case" selections are used withing Program, the program Completion ring stays at 100%.

Cian vor 7 Jahren in Metrology Software / Inspect • aktualisiert von neil kay vor 5 Jahren • 1

If you have a "Run another Part" selection within a Program, the total measurement cycle ring does not reset back to 0%, it remains at 100%.

GUT, ICH BIN ZUFRIEDEN.
Zufriedenheit
Zufriedenheit von Cian vor 7 Jahren
Abgelehnt
neil kay vor 7 Jahren

Inspect is "dumb" to the contents of the routine, so does not account for such inbuilt logic. However, in the next version of Inspect, it offers capabilities to "measure another part" at the end of execution, which you could swap to use. It also, with the playlist functionality, has the ability to multi execute a program 'n' times.

Customer support service by UserEcho