When evaluating distances and angles, the nominal value should be editable. 

In the current versions of TS, the setpoints are read from the pipe data and are not to be changed separate and manually.

Make tubeshaper software suitable for bending machines Schwarze Robitec and Wafios! We have troubles for so long now with the fact that everything is mirrored!

I would like that existed an option to be able to probe manually the intersection point between two straights that form a small angle (5 degrees, for example).

This option was implemented in Docs or GTube.

In TubeShaper we can export nominal or measured values, as CAD or as Supravision/Centerline files.

I would like to be able to import the measured values (as iges/supravision/etc... the best format you can find:) ) in order to have the opportunity of an off-line evaluation.

This can be used even in the condition that the measured files were generated from other software.

Add the ability to have the Bend Controller send "corrected data" to Tubeshaper and updating the CLRA fields only.  Currently as it is, sending corrected data to Tubeshaper replaces the nominal "LRA", which we want to inspect to.

Tolerances should be able to be entered separately for each intersection and for each Straight.    The overall tolerance does not always meet the specification,

especially for pipes with holders and connections.

The design of pipes over CAD or measured cylinders should be possible by clicking on the  cylinders and entering the bending radius.             

Currently, this is only possible through the tedious calculation of the intersection points and the rebuilding of a pipe.

When we do the Alignement with Plane Line Point, 

the Point should be Zero in XYZ.

We would like to have a possibility to see corrections of measured LRA in report. That means opposite values of deviations. For example when your nominal value of a bend is 90 and you measured that the reality is 91.5, the deviation is 1.5. But we would like to see the value of -1.5. We dont use automatic corrections for benders because our benders are not capable of this. We need to write corrections manually  so we need values in this form.