Il faudrait pouvoir importer en masse des fichiers .TSP

Lors de modification des paramètres et pour qu'ils s'appliquent à tout les fichiers existant, nous les copions et les réimportons ( + de 10000 fichiers).

L'importation en masse sur des fichiers .gtt est pourtant réalisable.

Cordialement

Fabien

ALLOW DISTANCE MEASUREMENTS THAT ARE NORMAL TO A SELECTED PLANE.

When inspecting tubes there should be different tones for successful measurement instead of failed measurement.  There should also be different tones for first scan versus second scan on each straight.   Most important - there should be a different tone when measuring ends - unique from straight 1/2 pass fail.   Again indicating success or fail of attempted tube end scan.   YES there are different tones already so different tones are available - but those varied tones don't associate with desired function.  

When you make an alignment , the point of alignment became origine(X0,Y0,Z0).

would it be possible to keep the coordinates of the cad(X135,Y588,Z15)!!

when i do an alignement PLP , the nominal of the cercle taken from CAD , is changed to X=0 Y=0 Z=0 then I have another nominal in my CAD. so my origin isn't the same but I want my origin in the same place.

IMPORTANT

This would help with our customers to better understand our data and our benders to understand what adjustments need to be made in process.

Measured value exceeding the specified tolerance will 

only be displayed in XYZ and T1 MP T2 "red" displayed.

Finding errors in LRA is very tedious and error prone, 

especially if the pipe has many straights.

It should be possible to enter and manage 2 or more pipes in TS within a project.             

This is important for tubes with ring pieces or assemblies.             

Since the function of TubeShaper goes beyond the pure curved tube,            

it is not clear to the customer why this is not possible.