LRA Errors must be displayed in Red

Holger 6 years ago in Metrology Software / TubeShaper updated by neil kay 4 years ago 1

Measured value exceeding the specified tolerance will 

only be displayed in XYZ and T1 MP T2 "red" displayed.

Finding errors in LRA is very tedious and error prone, 

especially if the pipe has many straights.

Image 120


Hi Holger-

      As mentioned previously, the TubeShaper team is reluctant to do any tolerancing of IP points as it's not a valid way to tolerance a tube.  Although we do understand that some customers do this, we are trying not to promote such practices as it can mean scrapping a perfectly good tube.   Additionally the "L" value here is a calculated value based on the TP's, and it itself is not actually measured.
          -The TubeShaper team