Scrolling through the Edit Window with the scroll wheel on the mouse is very slow, only about three lines per scroll. Can there be an option in the software to increase the scroll speed?

I think a nice addition would be an option to declare a datum within the creation of the feature.

Add the ability to have the position or out of tolerance display in the excel form report output. 

Suggestion:

Add Constrained L2 as a "bestfitmathtype" for ALL auto & constucted features.

Reasoning:

This would give users who use PCD's "Legacy Dimensioning" but do not want to use "Geotol" to create measured features that comply with the latest revision level of Y14.5 

Currently, you can do things like....measure a plane and then "CONSTRUCT" a PRIMARY plane...but I believe my suggestion takes the "primary/secondary/tertiary" construction stuff the rest of the way. 

The sphere measurement parameters needs the ability to spread the points across multiple levels. It currently takes only 1 point off the equator. If there is any error in this one point, it has 100% weigh on the calculated height of the ball. Any other point has a reduced weight because they are all taken on the equator. Having points on a additional levels would balance the Z-position of the calculated sphere.

Add an option within the Probe Utility dialog or under File Operations to allow copying and/or renaming of current probe.  Very often users create probes during program development and later on need to clean up or standardize naming conventions.
Would be great to be able to have system not only copy and/or rename the PROBE file, but also all of the dependencies.  Specially in the case of PCDMIS Vision as there are more files than just a .PRB involved.

I think it would be great to have the Name of the active "Marked Set" in an easily accessible variable in PCDMIS.

We often have Short and Lonv versions of routines. If that would be possible, one might have 2-3-4... marked Sets extracting the Name of the set from the variable to print it into the report...

For now You'd have to make for every marked Set something like MarSet = "Long Version" and mark it only in Long Version and so on...

Make that we can specify our own location where to save excel form report (other disk or network location). As I understand, now it has to be saved under users/public/etc. I is anoying to copy thoose files to our specific location on the disk. 

Graphic analysis should go more intuitive. especially in tool rooms, If I want to analyze the measured data of profile for example and with results showing OOT, I should be in a position to know the "area of improvement" which is the sole purpose of inspection. The graphic analysis should allow the user to have dynamic interaction under "administrator" ONLY privileges.  So, I should be in a position to remove the point or area of interest to check if the parts become OK or not ok directly in GDW. This capability should be available for all material inspections like PROFILE, FORM, and Hexagon can add whatever in addition on top of this. I also want to see the DATUM SHIFT just like a table being represented graphically and showing red/green in graphic and available tolerance after datum shift in green forex. This will help design cost reduction analysis and avoid unnecessary tolerance stack-ups or unwanted addition to feature tolerances graphically.  also, it should be dynamically updatable once the datum modifiers are removed in GDW AND HELPS THE product designer to make a decision. This is the next step in metrology software where the industries are heading for and I hope Hexagon wins the race here to differentiate PC-DMIS from other software.

Just like a PEEK window in a Summary mode, I would like to see the PEEK window for the CAD model. For example - When I hover a mouse over a CAD model and it is especially useful when I have measured lots of features in CAD and I don't want to switch to the summary mode and don't want to have labels or diminfo. ON to see some results, just hovering the mouse should display RESULTANT's ( diameter, XY info. , Height, Major/Minor dia, etc.) ONLY. based on current alignment for coordinate info. This will be very useful just like id's being showed up when hovering the mouse.