When I create  a new program I want to have the opportunity to chose filelocation for that new program . 

Under VIEW|OTHER WINDOWS|SETTINGS WINDOW

the tab in the settings window dialog "Probe",  should have a notification area for "FastProbeMode" status at current cursor position in the edit window. Either "on",  or "off".

Create a new setting that will allow the graphic display window to rotate and center to a new workplane whenever it is selected from the settings workplane dropdown. 

I would like to have oppotunity to save my settings. Menylayout, shortcuts, file locations and so on stored outside PC demis. So you can restore all settings by using this file to restore all settings after an update.

When constructing an extreme point on a feature that has been created using a series of points, PC-DMIS creates the point by selecting the point of the series that is in the extreme direction that you have selected.  This however is usually not the extreme point of the feature.  Can PC-DMIS calculate and construct the point at the true extreme of the feature?

add offset boxes in alignment window instead of having to compute the angle or add code to alignment 

PC-DMIS has an option to automatically save a program between the operator pressing the "play" button and the start of the run.  Why does this feature (which I've never found useful but hey, it doesn't hurt) exist but not one that automatically saves at the *end* of the run?  You know, *after* generating all the valuable data?

I can't be the only person on the planet where PC-DMIS sometimes crashes after an overnight run.  This just happened (again) last night and a 5h 49m lights-out run was wiped out!  It crashed so hard it doesn't even know it crashed; no error report was generated!

If you can't fix the problem can you at least make a workaround?

Causing circular move in diameter measurements while in MODE/MANUAL is also off. There is a solution, but it would be more practical to be open.