After Collision Detection has been run have only the Feature ID's on the Collision List appear on the Graphics Display Window.    This will cut down the amount of searching for a feature that occurs.  

Better yet, have collision detection automatically run as you offline program.

Instead of clicking start/end points for a scan segment to construct a feature, I would like to be able to click a CAD surface so that all hits that cross that surface are included in the feature construction

PC-DMIS ability to recalculate actual values of current measured values in case of probe re-qualification, i. e. when using a probe angle that wasn't qualified a long time ago and it was used in a routine that takes a long time to run.

IT HAPPENED TO ONE OF MY PROVEN PROGRAMS THAT ONE AUTO FEATURE MOVED TO A NEW LOCATION BY ITSELF SOMEHOW. IT DID BREAK TIPS. WE SHOULD PREVENT IT FROM HAPPEN TO MAKE SURE PROVEN PROGRAMS ARE SAFE TO RUN.

If the point numbers in the min/max list matched the actual feature point number then I wouldn't have to rely on the low screen resolution on graphical analysis to find where the min/max locations are.

Currently, Point Auto Trigger only allows for a radius to be set. This creates a cylinder that has no ends and allows for points to be taken anywhere inside the diameter created...even if its 1000mm away from the target. Often times the point is taken on the wrong side of the part by the operator... Please add a control for the max distance from the surface similar to that used for laser scanner features.

Help files attached to the icons. Hover over the icon and get a pop up (help?)that links you to the help files associated to the icon.

Create 3d Cad features from the features created in the program. Use the upper and lower tolerance to create boundaries then use the measured value to confirm the features are in tolerance visually. Apply datum shift to allow a virtual fit up. Features that don't "fit up" appear red and a list of features is also reported "like collation detection". Works with legacy or exactmeasure...

ABSOLUTE MOVE POINT SHOULD BE VIEWED AS A VISIBLE OBJECT LIKE A REGULAR POINT SO IT CAN BE EASILY FOR MODIFYING

Add (enhance) the ability to create multiple auto features in on go.

I know you can create multiple auto features in one go by left click dragging a box around them, but it always picks up several 'hidden' features which aren't wanted, and yo get no say in the order of them.

What would be ideal would be ctrl+click (like selecting multiple discrete items from a list box) to select multiple features at once.