Ideeën
+14
Construct Line should allow the intersection of a cylinder with a plane which is parallel to the axis.
frank herr 5 jaar geleden
in Metrology Software / PC-DMIS
•
bijgewerkt door neil kay 5 jaar geleden •
2
Construct Line should allow the intersection of a cylinder with a plane which is parallel to the axis. To get both possible lines we can use the plane vector.
Customer support service by UserEcho
It would be helpful for 3D geometries to create a line/circle: cone geometry, sphere geometry, torus geometry.
For 2D geometries, it should also be possible to create a point when cutting a plane with a circle geometry or a line geometry.
This function would make my daily work easier.
While waiting for this to be implemented,
https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/446868-2-intersection-points-from-one-circle-and-one-plane?p=446922#post446922 shows a relatively simple way to get the points from circle/plane. With those points, it's easy to produce the OP lines.