1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Idéer
+14

Construct Line should allow the intersection of a cylinder with a plane which is parallel to the axis.

frank herr 5 år siden i Metrology Software / PC-DMIS • opdateret af neil kay 5 år siden • 2

Construct Line should allow the intersection of a cylinder with a plane which is parallel to the axis. To get both possible lines we can use the plane vector.

Benjamin 5 år siden

It would be helpful for 3D geometries to create a line/circle: cone geometry, sphere geometry, torus geometry.
For 2D geometries, it should also be possible to create a point when cutting a plane with a circle geometry or a line geometry.

This function would make my daily work easier.

anders isaksson 5 år siden

While waiting for this to be implemented, 

https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/446868-2-intersection-points-from-one-circle-and-one-plane?p=446922#post446922 shows a relatively simple way to get the points from circle/plane. With those points, it's easy to produce the OP lines.

Kundesupport af UserEcho