Идеи
0
Make it possible to delete hits from measured features from within the hits dialog
Jörgen Andersson (vpt se) 6 лет назад
в Metrology Software / PC-DMIS
•
обновлен neil kay 5 лет назад •
5
Like the title.
I use measured features a lot (placing hits with mouse/joystick) especially on surfaces/planes.
I have found it quite cumbersome to delete a certain hit from the feature, as you first need to
"find" the hit - either in the command or by using the "hits" dialog for measured features:
After that, you will need to find the actual hit in the command and remove it.
Then, repeat the procedure until all the hits you want to remove are gone.
I would like to have the possibility to multi-select the points I want to remove
through the dialog shown in the image.
Сервис поддержки клиентов работает на платформе UserEcho
What version are you running? I can't find that window.
Measure Dialog window
Example: Measured Point
Select Hit Targets
Example: Within the Feature Hit Targets dialog window double left mouse click the hit feature #1: 0,0,0,0,0,1
will open the Measured Hits dialog window. Within the Measured Hits dialog window you can change the Hit Type. Corner and Angle I have had issues within the past. The Surface Hit Type is an alternative too the Surface Point Auto feature.
I look back at this Feature Hit Targets Dialog Window in the 3.6 manual to find a Delete Hit button. Nice, there was a delete button for this dialog window.
From the pcdmisv36OnePDF Chapter 15 Page 639:
I just had to look back and find this missing delete button. I remember using this button when I was using v3.6. Not sure when this button was removed.
Thanks, Dave!
Well, actually it is still possible to delete hits by simply hitting the <delete> button on the keyboard, but I would like to be able to multi-select (CTRL + leftclick) in the hits list to select several hits for deletion. As they get marked in the list, they should also be marked in the graphics view (like current state).