1. Hexagon Measurement Systems
  2. Metrology Software
  3. TubeShaper
  4. Ideen
+1
Fertiggestellt

Make tubeshaper support more non-round geometries. (square/rectangle)

Christian Grindle vor 6 Jahren in Metrology Software / TubeShaper • aktualisiert von anthony vianna vor 4 Jahren • 6

We are a job shop that does everything under the sun, tubes being no exception.  We really need tubeshaper to be able to measure non round geometries.  Round tubes are only half of our tube product mix.     Please help!!!   

neil kay vor 6 Jahren

Moving to the TubeShaper forum

anthony vianna vor 5 Jahren

We're working on something you might like Christian! More details in the next few months.... :-)

anthony vianna vor 5 Jahren

Christian, some test tubes would be really helpful to us in testing. Please could you contact cs.arm-pl@hexagonmi.com so that we can organise this?

Christian Grindle vor 5 Jahren

Anthony.  I tried but the email came back as undelivereable.   Please email me at christian.grindle@gsmwinc.com

anthony vianna vor 5 Jahren

Christian we're almost ready to go. We'll be releasing v2 of TubeShaper in January, and it will support square and rectangular tubes. If you'd like to test this before release, please let me know! anthony.vianna@hexagon.com

Fertiggestellt
anthony vianna vor 4 Jahren

TubeShaper v2 was rolled out in March 2020. Did you give it a look? It can now support rectangular section tubes.

Customer support service by UserEcho