Idées
+11
Terminé
Set the limit angle value to measure 180° bends
Nicolas Pétré il y a 6 ans
dans Metrology Software / TubeShaper
•
mis à jour par anthony vianna il y a 3 ans •
3
Today, 180° bends require additionnal point when the angle is higher than 178° (?).
This limit value should be editable (tupe inspectionsettings) to be able to operate the same way on slightly smaller angles (175° for inst.).
Service d'assistance aux clients par UserEcho
It will be useful to open this possibilities also for a all angles like an option. Also when the angle is very short (5º degrees for exmple).
We think that this topic has been addressed now in v2.1 of TubeShaper. Take a look, and let us know what you think!