Integrate leapfrog using touchprobe

sebastiaan kuiper 5 år siden i Metrology Software / TubeShaper opdateret af anthony vianna 2 år siden 2

Please integrate leapfrog using touchprobe. When doing the current leapfrog (measure last two straights) it is sometimes not possible to measure tubes with a very long straight (2000-3000mm) in between the bends with a "standard" tubearm. This will be possible using a traditional leapfrog (or two).

The use of a "T" to displace the tube on long straights is scheduled.

Same function as GTube.


This can already be done with a touch probe, through RDS.

Kundesupport af UserEcho