Suggestion for a filter for laser COP

One filter that I really wish was available for a laser-scan COP is a one that just removes all laser points within x distance of a seam in a solid model.  Trying to get a surface profile measurement of a scanned part is inevitably thrown off because the physical part has had the edges smoothed per drawing requirements, but the model had sharp edges so it shows up as an out-of-tolerance condition.

I'd love to have a filter were I can specify a distance, and then either select individual seam lines or just pick "all seams" to filter out these edge points from the COP.

A .015"/.005" break edge requirement means on a .010-profile surface all of the edges will be out of spec, and the measurement will not be an accurate representation of the part.