1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Ideeën
+4

Have the clearance cube wrap around the form of the part instead of a cube that has deadspace in it

Richmond 11 maand geleden in Metrology Software / PC-DMIS • bijgewerkt door Daniel Sylvester 6 dag geleden • 1

This would save lots of time for some parts. Think of it like the shield from the Dune movies. The clearcube should form around the part

Daniel Sylvester 6 dag geleden

I work with a lot of lathe parts. Square clearance cubes are a little overkill. Your idea is probably better. Parts with large cavities would be much easier to run.

Customer support service by UserEcho