Probe Utilities

Add a Search box to search for a specific tip.

Add a Sort to have the ability to ascend or descend tips.

Add the ability to Hide unmark tips after selecting Mark Used.

As far as I know Program Mode is only used with Measured Features.  Makes sense to me to take it off the graphic modes toolbar and move it to where it is used.   Easier to find and semi-logical.  

We often have to measure very small optical flatnesses on contact surfaces. 

Here it would be useful if I had to Focus with once window only. 

Simply define the measurement window and the division of the measuring range analogous to the measuring method from Werth GmbH.

Offer the same simple way to swap measured features between polar and cartesian coordinates, as is possible in auto features.

Canned  dimensional support for:

-Measuring a fixed radius then measuring an average point back to it's center point.

-Measuring a fixed radius then reporting out the high and the low points back to center and giving a max and min radius.

The ability to lasso CAD points when picking your Boundary points when creating your scan

When I create a part loop for 100 parts I would like the ability to run probe 1 on all 100 parts before switching to probe 2 and starting at part 1 again with the correct alignment.  If i create both probes in same loop program it takes more time changing probes than it does checking each part. The loop does create the alignments like this ABC[1] right now but once out of the loop and switching to probe 2 their is no way to recall alignment ABC[1] and start from part 1 thru 100 again. This would eliminate having to create external alignments using variables.

Add a backup folder to the Set Search Path list.  When program is protected also back it up to the backup folder.

The ability to modify targets without effecting alignment changes. 

Currently if I mirror a program or change an alignment - my target formula does not change it's nominal value.  Therefore the CMM drives to the wrong place.  Sometimes by 1000's of mm.  Because this is not supported in this way our company frowns upon the use of assignments.