Add the ability to recall a Measurement Strategy Editor group directly in a Auto Feature Dialog box.   Should result in less opening and closing of dialog boxes.

I'd like to have a graphic view of the roundness deviation of a stylus to determine what points on the stylus seem to be giving me the deviation.

how to added probes that they are not in the probe prescription.

I'd like to have the filtering options available in scans (liner open, closed, freeform,etc) rather than having to construct a separate filtered feature set for each scan performed.

Change the Comment Yes / No Auto-continue execution Default settings to be uncheck (Off). 

Every Time I want to place a Yes / No Comment into the program I have too always uncheck the "Auto-continue execution". If I don't uncheck this check box I will get a Warning message "Enter an integer between 1 and 600" after selecting "OK". 

When inspecting tubes there should be different tones for successful measurement instead of failed measurement.  There should also be different tones for first scan versus second scan on each straight.   Most important - there should be a different tone when measuring ends - unique from straight 1/2 pass fail.   Again indicating success or fail of attempted tube end scan.   YES there are different tones already so different tones are available - but those varied tones don't associate with desired function.  

When a program execution is stop within a Group the Set Start Point will not be visible. With a large program that contains a large amount of Groups this can be difficult to find the Set Start Point location. Add a Set Start Point at the beginning of the Group and with the Group expanded move the Set Start Point at the last place of execution. This will eliminate the need to expand all Groups to locate the Set Start Point.

The Custom Probe Builder should be available for all PC-DMIS CAD versions. This would be another addition to improve the UI.