When a program execution is stop within a Group the Set Start Point will not be visible. With a large program that contains a large amount of Groups this can be difficult to find the Set Start Point location. Add a Set Start Point at the beginning of the Group and with the Group expanded move the Set Start Point at the last place of execution. This will eliminate the need to expand all Groups to locate the Set Start Point.

The Custom Probe Builder should be available for all PC-DMIS CAD versions. This would be another addition to improve the UI.

Tabs are not easily visible when selecting "Best fit" in the alignment window. They are  partially blocked by the DOF window 

Append function

Possibility to save measurement results in the same worksheet.

Unable to import Feature Data with Feature Id's starting with a Number. But, can export Feature ID's with a number. So, if you can export Features in a certain format then you should be able to import Features in the same format that it was exported from. If not then add a warning in the export that this format will not be able to be imported into the program with this type of format. 

I'd like the title bar to show the service pack number of the currently installed version. This would be useful for us Support guys.

Enhance the paste with pattern dialog box so that one could copy a feature, set the offsets in the dialog box.

Have a button to paste with pattern the pre-copied feature inside the dialog box and another button to perform the newly created features upon closing the dialog box.

Quick Fixture - Export Quick Fixture Components with Part.

Ability to export the complete Quick Fixture components and part setup.

I tried to create a 3d pdf with a quick fixture component and only the part model will be shown with the 3d pdf using 2018 R2.
Therefore,  you are unable to display the complete quick fixture components and part setup in a 3d pdf.