الأفكار
+1
Dimension the width between circles
Add the ability in the distance dimensioning to be able to report the width of an O ring groove between two circles.
خدمة دعم العملاء من خلال UserEcho
الأصوات الموجودة: 10/10
الإجراءات
إحصائيات الموضوع
- 1 الأصوات
- 1 الردود
- 2 متابعون
- 2780 عدد المشاهدات
I can see some pitfalls with this, especially if the circles aren't concentric...
(CIR1.DIAM-CIR2.DIAM)/2 would give you the width of the groove regardless of the position of the circles, but if you are certain they are concentric, then sure.
A function like this could be dangerous, depending on (knowledge of) the operator using it.
Then again, diameter + concentric evaluation combined into one function could give you a max/min type of (calculated) distance (discarding roundness of the diameters).