1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Ideas
0
Completed

Safety request by probe swivel,

Wolle 7 years ago in Metrology Software / PC-DMIS • updated by neil kay 5 years ago • 3

When using executing program parts by CTRL + E, PCDMIS automatically swings to the last programmed probe position from the program.

Unfortunately alsothis position is skipped by an IF / GO command.

 Here would be a safety requestion befor the swivel useful.

GOOD, I'M SATISFIED
Satisfaction mark
Satisfaction mark by Wolle 6 years ago
Derek 7 years ago

Make sure that is highlighted box on the left is UNCHECKED

it will give you warnings from that point on.

Wolle 7 years ago

Hello Derek,

Thanks for the answer. However, this is only the case when the probe is called in the program sequence. But not by works with Strg + E.

In my case, if I use the command "goto", then the probe will go to the last position but this command is skipped by the "goto". And then without a message!

Completed
neil kay 6 years ago

Customer support service by UserEcho