1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. Ideas
+2

AUTO PLANE RINGS

barnett_james 12 months ago in Metrology Software / PC-DMIS • updated by David Phillips 12 months ago • 2

I would like to see an option where we can adjust the distance between multiple rings when checking a radial auto plane. We of course have the option to adjust the size of the rings but, to my knowledge, don't have the option to adjust the distance between.

Wesley 12 months ago

There is an option called 'spacer' to adjust the distance between rings.

But an option to set the diameters of the smallest and largest rings would be a welcomed addition.

Aslo the option to place a point in the middle would be nice.

David Phillips 12 months ago

This would be great for Flatness Call outs for Bolt holes. 

currently construct generic circles around bolt hole smallest to largest

then type value smallest diameter Plane then # rings

then manually drag points to match generic circles for each pass.

Customer support service by UserEcho