1. Hexagon Measurement Systems
  2. Metrology Software
  3. PC-DMIS
  4. الأفكار
+1

PCDmis always uses circular moves on spheres

Smasherofprobes منذ 3 سنة في Metrology Software / PC-DMIS • تم التحديث من قبل Ale منذ 4 أسبوع • 3

Constantly having to check the box for "Circular moves" when picking up Tooling Spheres in DCC. It should default to circular moves when measuring spheres! I understand there is an option in F5 to "Use circular moves on round features", but I only want to apply this to spheres.

Ale منذ 3 سنة

Hi, fully understand the request. I'll monitor this item to see if there's general consensus for a change. Thanks.

Smasherofprobes منذ 3 سنة

TY :)

Ale منذ 4 أسبوع

This is available since PC-DMIS 2024.2.

خدمة دعم العملاء من خلال UserEcho