As a programmer I would appreciate more options in the ClearanceCube settings.

We load 3D data into the programs in coordinate systems as we receive them from the customer. This is due to future changes in the 3D data. If the 3D data is not in the "ideal" coordinate system, we have no way to fit the ClearanceCube as we would like.

Here is an example of such a problem:

It is clear that I can hard modify the 3D data to get it into the "ideal" coordinate system, but that would mean doing it every time a customer sends me a new version of the 3D data, and that is not the best way to go.

add excel form toggle to the dimension "output to" section

Meine Idee wäre es bei Auto Element Kreis auch mit Teilsegmenten wie an der Optiv zu arbeiten (Punkte Auswahl Messbereich). Somit könnte man Messbereiche einfügen und separat definieren. 

Meine Idee wäre, mit Auto Element Circle auch mit Teilsegmenten wie beim Optiv (Punkteauswahl Messbereich) zu arbeiten. So könnte man Messbereiche einfügen und separat definieren.

I want the ability to add comments to reports after a run to explain why some dimensions are red on the report, and to type in the dimension we get when measured manually. 

I dont want the comments to stay there for the next run. So it doesn't function as a label only as a comment for the specific run. 

Hello,

After tip calibration, user has to go "Results" to see calibration result. If not, user has no idea about it or user can forget to check result. To prevent this, we can use a check box such as "show calibration result after calibration is done" in Setup or somewhere else. With this box checked, user can be able to see Results immediately. This prevents that if results are bad, it cannot be overlooked. 

Best Regards. 

Hello,

As you know, Lower Matrix Calibration is essential to use analog probes correctly. However, I see that so many customer does not realize the importance of it and they neglect doing it. This causes problems in measurements. We have so many mails coming to hotline about inconsistancy between probes, tips, etc and most them are related to lack of Lower Matrix. 

In my opinion, we need to have option to remind Lower Matrix such as in Probe Utilies, Setup like reminder for Probe calibration hours and days. 

Best Regards. 

When translating a CAD model be able to select a feature and tell the software to rotate to a specific direction.  Select feature, Rotate to "specific direction" , OK and DONE